FAQ for Z32 3 Gauge Cluster - DIN Mount

Your add says 52mm, what about 2 1/16" gauges?
2 1/16" gauges fit fine, they are almost exactly the same size.

How do I attach the gauges to the panel?
If the gauge has mounting hardware to attach it to a panel you should use it, otherwise use RTV silicone as a temporary adhesive if the fit is not tight enough to hold it in place.

How do I attach the panel to the factory radio bezel?
After trimming the bezel so the DIN panel will fit, you will need to glue the panel in place using RTV silicone or epoxy adhesive.

Will the panel fit the upper DIN hole?
No. It is fitted specifically to the lower opening.

I want to put a boost controller where the clock is located. Can I buy the radio bezel from you?
No. We do not sell any OEM parts. Contact your favorite OEM part supplier, new or used.

Is there a version for right hand drive cars?
No.

Copyright © 2003-2018 300 Degree LLC, All Rights Reserved.